RLE WiNG THRM Thermistor

Wireless Transmitter with Thermistor Input

The WiNG-THRM Wireless Transmitter offers the placement of temperature sensors in areas (such as air ducts, pipes, etc.) of a data centre that normally would not allow a wire-free radio transmission. The sensor and external transmitter are connected by wire, the latter converts the analog into wire-free signals and transfers these to the WiNG Manager. The transmission range between sensor and management unit is up to 180m. When using an optional WiNG Range Extender this range can be extended up to 300m. The WiNG-THRM module is available in 900 and 868 MHz configurations.

Highlights RLE WiNG THRM Thermistor:

  • Converts a wired analog input into a wire-free radio signal
  • Wire-free transmission of temperature data in and out of difficult to access data centre areas
  • Fully compatible with WiNG Manager and additional WiNG Range Extender
  • Up to 12 years battery life
  • Wire-free: 868 or 900MHz (model dependent)
  • Accepts one wired 10K-2 thermistor input (12bit A/D conversion)                     
  • Signal transmission every 10/20 seconds (polling rate) to the WiNG Manager
  • Packet transmission accuracy that exceeds 98%
  • Transmission range between sensors and manager:
    • Up to 30,48 m (100‘) through multiple walls
    • Up to 82,3 m (270‘) through one wall
    • Up to 182,88 m (600‘) direct line of sight
    • Up to 304,8 m (1000‘) direct line of sight with a WiNG-RXT range extender